3D Printed Ghost Keychain

Well, I had white PLA loaded in the 3D printer, so I was on the lookout for another cute print project I could do without having to switch the filament, and I came across these cute ghost keychains.

I set it up using the instructions listed (.2 resolution 15% infil) and printed it on our printer using white PLA.

It printed in about 20 minutes and turned out pretty well!

Since the first one turned out pretty well, I printed a couple more and raided my craft stash for some keychains.

Unfortunately, I ended up with some dark areas in my white filament on all three of the ghosts. I don't know what's causing that (junk stuck in the nozzle? heat set too high? burning hairspray since I use that for bed adhesion?). So if anyone knows what's going on, let me know. I've really only noticed it happening with the white filament.

So even though there were some dark spots, the key chains turned out pretty cute. I'll probably check out some of the designer's other keychains in the coming weeks.


Popular posts from this blog

Plastic Wrap Alcohol Ink on Small Ceramic Bowl

Splatter Resist Alcohol Ink Tile

Alcohol Ink Washer Necklaces