3D Printed Pull-Apart Wishbone
Just a quick silly Thanksgiving themed 3D print this week. I found this pattern for a pull-apart wishbone on Thingiverse and decided I needed to give it a try.
I used standard settings (.2 resolution and 20% infil) and some brown pla filament to print this quick project on our printer. I did have to enlarge the pattern quite a bit in the slicer, though. In the comments, the creator recommended a 2,540% increase, so that's what I went with.
The project printed in about an hour and a half and fit together really well. The instructions said if the bones don't fit together tightly, you can use a lighter to adjust. Be really careful, though, a lighter can melt pla very fast.
Ours fit together well. I might have to make one in white, too.
Comments
Post a Comment