3D Printed Heart-Shaped Vase


Well, I had to print something fun for Valentine's Day, and when I found this cute vase, I thought I'd give it a try. It's described as a Love and Kisses vase since it has as heart-shaped base and opening and a pattern of Xs on the sides.


I printed the vase using the recommended settings of 0% infil in vase mode/spiralized. I used a red PLA which is a beautiful shade of red in person, but apparently a shade that is really difficult to get good photographs of.


The vase setting is so much fun to watch print. The print goes up really fast. One minute it's printing the base and ten minutes later it's going vertical.


This vase is about 5 inches tall and took about an hour and a half to print. It turned out really cute for a quick little print project!


Check out some of the other Valentine's Day projects here: Valentine's Day Craft Collection.

Comments

Post a Comment

Popular posts from this blog

Plastic Wrap Alcohol Ink on Small Ceramic Bowl

Splatter Resist Alcohol Ink Tile

Alcohol Ink Washer Necklaces