3D Printed Cotton Round and Cotton Swab Holder
Yet another 3D printing project from our new printer this week. Check out our previous print projects here: 3D Print Projects.
This week I decided to print something I knew would be useful. I use cotton rounds every day to clean my face, so when I saw this little organizer I knew I had to print it.
I followed the instructions on Thingiverse except that we opted to printed it from the bottom up (I rotated the design when I was slicing it to prepare the print).
It took about 6 hours to print because it was set to 50% infil (so the walls and base weren't hollow--they were filled 50%) to make it sturdy, but it came out perfectly!
This print job is going to get used a ton!
Comments
Post a Comment