3D Printed Window Pumpkin


I came across this cute window pumpkin and new it was the perfect 3D printing project for a busy week in October.


I loaded some orange PLA into our 3D printer and set up the file using standard resolution (.2) and 40% infil.


The designer of this print project was really smart to put in those divots in the bottom of the design so that when the print project was finished, it was easier to pull up from the bed.


The project took about 4 hours to print in total.


The finished print came out super smooth. I was really happy with the finished surface. The pry divots worked perfectly. I was able to pop it up off the print bed after letting it cool for just a little while.


I used a small suction cup to hang it in the window. You can see the infil pattern and the pry spots when the light shines through it, so be sure to pick something that you'll like the look of.

Comments

Popular posts from this blog

Plastic Wrap Alcohol Ink on Small Ceramic Bowl

Splatter Resist Alcohol Ink Tile

Alcohol Ink Washer Necklaces